Dating fender guitar pots
I was told some weird info yesterday by a well respected figure who works for Sam Ash corporate.We were talking about recent changes at Gibson, Henery's insanity, failure to note their customer base's preferences, etc.#3755 25K-ohm For controlling the volume or tone of active pickups, or for use after the preamp of a piezo-saddle transducer bridge.#0128 250K-ohm & #0130 500K-ohm500K pots are standard controls for humbuckers, and 250Ks are usually used for single-coil pickups.When striking a chord on your guitar, the whole value chain of electrical components must quickly transport a large amount of energy (current) to the loudspeakers.Tube amps usually have a slower response time than transistor amps.Alpha pots are audio taper with standard ±20% resistance tolerance.
It turns out it was double boxed with the Gibson box inside this one... As part of the new role, Slash will develop new products for the Gibson Custom, Gibson, and Epiphone lines.They have this sweet spot where you are just in between clean and distorted lands.You may have heard that transistors are distorting differently and harder than tubes caused by a distinct and sudden signal clipping when max effect level is reached in the transistors.A 250K gives a slightly warmer tone than a 500K, and bleeds off (attenuates) some of the high frequencies to ground.
A 1-meg pot attenuates even less than a 500K—try one if you want to hear your guitar "wide open." #3481 1 Meg-ohm Get the most out of your guitar with a 1 Meg-ohm pot.
The cream-colored board is laid out entirely differently (and better) than the green board. But the old ones sound darker, while the new ones are brighter, with more emphasis on treble tones.